Operation Basic Operation - Haier LE42K5000A Owner's Manual

Operation
04 OPERATION
Basic Operation
Power supply to switch on/off this Unit. Before switch on,
ensure that all connections will be proper and correct.
Press Power on/off (at the botton of the rear panel of this
Unit) to turn on/off this Unit. When the power indicator turns
red, this Unit accesses the power on and standby state.
Press key to start this Unit.The power indicator turns
Press key once again to switch off this Unit.
If there is no signal for the current signal source, this unit will
automatically set to the standby state 10 minutes later.
If not to use the main Unit for a long time, unplug the AC
power cord from the AC outlet.
Select input signal sources
After turn on the main unit, press source to select proper
input source. Press▼▲ buttons to select the main signal
source. Press OK button to confirm.
Source
DTV
ATV
AV
SCART
Component
HDMI1
HDMI2
HDMI3
Media
Setting the OSD Menu
Press MENU button, and the main menu appears. the main
menu display in turn as below:
Picture→Audio→Wide Mode→Channel→Time→Setup
When display of some menu option is gray, it indicates that
such options are not available under the current mode.
General Step for Menu Setup:
●For each main menu, first press▼ to enter the submenu.
●Press ◀▶ to select the desired adjustable option.
●Press ◀▶ to adjust to suitable value.(There is ▶ option
only following such menu, then press ▶ key only)
●After the selection of option is completed, press Menu to
be able to quit the menu.
Installation Guide
The installation guide only appear when the TV first time
turn on or reset to factory set.
Please select an OSD language
English French Italian
Dutch Russian
Polish
Greek
Hungarian
Portuguese
13
off.
Spanish German
Czech Romanian
Arabic
Thai
Password
Please enter new password
Confirm new password
Confirm
1). Press the ▲▼ buttons to navigate the menu and change
the settings. Press the OK button to confirm.
Select your desired language to be displayed on the menu.
Input your password and press confirm to complete.
Note: The default password is 0000.
Home And Shop modes
2). When the unit is turn on for the very first time, it will show
Initialization set-up menu. After the OSD language is set, the
user can choose between "shop mode" and "home mode".
When the screen shows the following setting menu and the
cursor stays on the "home mode" choice, press ◀▶ to adjust,
and "OK" to enter the menu.
Select the usage mode?
Shop mode is for shop usage only.
Shop Mode Home Mode
If "Home mode" is choosen, the following menu will displayed.
Confirm
Are you sure to change to Home mode?
OK
Choose "Cancel" to go back to the Initialization set-up menu.
Choose "OK"to enter the Network menu.
Network
Wired
Network
WI-FI Network
Move
Press the ▲▼buttons to select network type,then press the
OK button to enter the submenu. After the Network is set ,
press the ▲▼buttons to select "Confirm" and then press the
OK button to confirm .
3).The following menu will display.Press the ◀ ▶ buttons to
select DTV/ATV and then press the
OK button to confirm.
DVB Tuning Type
DTV
ATV
Cancel
Network
Not Connected
Not Connected
Not Connected
Confirm
Enter Back
OK