Display Information,Option Buttons; Additional Functions - Siemens WM08X160IN Operating Instructions Manual

Display information, Option buttons
Display Information
wash: Not on if Rinse
flashing: too much detergent used
Rinse: Not on if Spin
Spin: Not on if "
On: the door can be opened;
flashing (after programme starts): the door was not closed correctly
for programme status
: On: childproof lock is activated;
flashing: the setting was changed -> page 6
800 : Default spin speed of the programme
: Rinse hold
1:30: Expected programme duration
24h: Select Finish in time
: End of programme
Display Information
: Fault displays
Display information
depends on the
: "YES" if the door can be opened or "NO" if it cannot be
chosen programme
opened during "Pause" period
Option buttons
Spin
You can change the indicated spin speed. The maximum spin speed which can be selected
depends on the chosen programme. You can also set "
the final rinsing water.
Finish in
Before a programme starts, you can specify by how many hours later the programme is to be
ended.
– Press Finish in button until the required number of hours is shown. The Finish in time can be
set in hour increments up to a maximum of 24 hours.
– Press Start/ Reload , the Finish in time starts counting down.
You can pause the programme to open the door even if the Finish in time is active.
, Spin or Empty
is selected
page 13
or Empty is selected
" Rinse hold is selected
page 11
" (Rinse hold), the load is held in

Additional functions

Buttons for additional functions
speed Perfect For washing in a shorter time with a washing outcome comparable to
that of the standard programme.
Additional rinse cycles, extended washing time.
Extra Rinse
For areas with very soft water or for further improvement of the rinsing
result.
Childproof lock
– Activating the childproof lock: After the programme starts, press Start/Reload
down for 5 seconds until the
The symbol flashes if any setting is inadvertently changed.
– Deactivating the childproof lock: Press Start/Reload
the symbol goes out.
– If the programme is ended or any setting is changed, deactivate the childproof lock.
– If the programme is changed while the childproof lock is activated, the
the programme which is running will continue.
– If the childproof lock is deactivated while the programme selector is in a different position
from when the childproof lock was activated, the programme which is currently running be
halted.
Soaking Load washing of the same colour.
Pour soaking agent/detergent into dispenser II according to the manufacturer's instructions.
Set programme selector to Cottons
10 minutes press Start/Reload
re-press Start/Reload , if the programme is to be continued or change the programme.
Signal
1. Start the signal
mode
Set to Off
Button feedback
2. Set volume for...
signals
set volume*
*If required, set the volume
repeatedly.
Sleep mode
If you do not operate the machine for about five minutes after selecting the programme or
programme end, the display information goes out to save power.
– If required, press any button, and all information will be displayed again.
5
In addition to the programme if required
Programme will not be changed by accidental operation.
symbol is displayed.
and hold down for 5 seconds until
40 °C and select Start/Reload
to stop the programme. After the required soaking time
+
1 step
Press Spin and
clockwise
hold and
Information
signals
directly
1 step set volume*
clockwise
and hold
symbol flashes,
. After approx.
Release the
button to find
the number
Set to Off
6