Initial Setup And Touch Screen Correction - Pharos 505 User Manual

Chapter 2: Basic Skills

Initial Setup and Touch Screen Correction

When using your Pocket PC for the first time, follow the initial setup
procedures below, after the battery has been charged. When you slide the
battery switch to the "supply" position
powers on automatically and the Welcome screen appears. Tap the screen
to start the following setup.
1. Complete the touch screen correction.
When the align screen appears, tap the center of the cross target with
the stylus. The next target position changes upon tapping the target.
Five taps completes the positioning correction. The screen then
changes to the stylus screen.
If an object touches the screen during correction, the
NOTE
correction is cancelled. Repeat the correction procedure.
2. Follow the on-screen instructions describing how to use the stylus, and
then tap Next.
For more information on stylus operation, see "Using the
NOTE
Stylus" earlier in this chapter.
3. Follow the pop-up menu instructions.
n
Read the on-screen explanation and then follow the instructions.
Display the pop-up menu, and then cut and paste the data
according to the screen instructions.
n
After you finish the paste operation, tap Next.
4. Set the time zone.
n
When tapping the ? mark, the city and the time zone list appears.
Tap the desired city and time zone.
n
When the setup is completed, tap Next.
5. Complete the initial setup.
n
When the complete screen appears, the initial setup is
completed.
n
After tapping the screen, you can use your Pocket PC.
When you tap the complete screen, the Today screen
NOTE
appears.
- 24 -
and install the battery
, your Pocket PC