Advertisement
Cleaning
Be sure all control knobs are in the OFF position before cleaning.
Cast
Iron
Solid
Elements
The body ofthe solid element is madeof high strength cast iron. The red lacquer
dot and saturn ring on the elements will eventually disappear after the element
has been used or after it is scoured. The cast iron will also lose its dark luster
over a period of time. (See instructions below for restoring cast iron. ) These
changes will not affect the solid element's performance or durability.
IMPORTANT
BEFORE USING THE COOKTOP FOR THE FIRST TIME, HEAT THE
ELEMENTS WITHOUT A PAN FOR 3 TO 5 MINUTES ON THE HI
SETTING. The elements are shipped with a coating (lacquer) which
protectsthem againstcorrosion. Heatingthe elementsallowsthe coating
to be hardened and burned intothe elements. Duringthe curing process,
a non-toxicsmokewill be created. Turn on the ventilationfan if the smoke
is objectionable.Ifthe elementsarenotcured,the coatingcan sticktoa pan
when first used onthe solid element.
•
Fornormalcleaning,wipe the element witha damp cloth. Heat element
on a medium settingfor a few minutes untilcompletelydry.
•
For light soil, use powdered cleansers such as Bon-Ami, Bar Keepers
Friend,or soft scrubbingcleansers. Rinsethoroughly. Heat elementon
a mediumsetting untilcompletelydry.
•
For heavy soil, use soapy scouringpads such as S.O.S. or Brillo, a
scouring pad such as Scotch-Brite, or a brush with scouring powders. To
facilitate the cleaning process, first warm the element on a low setting.
Rinse thoroughly after cleaning. Heat element on a medium setting until
completely dry.
•
For routine maintenance and to restore the cast iron, use Collo Electrol
(Jenn-Air ModelA911 or Part No. 712190) or salt-free vegetable oil. Apply
the Collo Electrol by following package instructions. When the element is
cool, use a clean cloth to remove excess polish. A very thin coatof salt-
free vegetable oil will also restore the appearance of the cast iron. Apply
with paper towel to a lukewarm element, wipe off excess, and heat on a
medium setting to cure. If too much oil is used, the surface can become
tacky. If this happens, use procedures recommended for cleaning heavy
soil.
•
Remove any foods spills and spatters from elements as soon as possible
with a damp cloth. Dry thoroughly.
Advertisement
