Center Speaker - JVC MX-DVB10 Service Manual

MX-DVB10
< Subwoofer >
Removing the front cover
1.
Remove the four screws D on the front of the body.
2.
Remove the front cover from the four holders marked
b that are fixing the front cover.
3.
Pull out the front cover toward the front while
disengaging the four joints marked b.
Note:
Because it is difficult to take away the cover,
insert a minus driver, etc. in the place between
the main body and the front cover as shown in
Fig.1 before removing the front cover. Exercise
care not to damage the main body and the front
cover when inserting the minus driver. For this
purpose, insert the minus driver together with
cloth and the like.
Removing the subwoofer
Prior to performing the following procedures, remove
the front cover.
1. Remove the four screws marked E on the front of the
body.
2. Pull out the subwoofer speaker toward the front and
disconnect the wire (red and black) from the
speaker terminals.
< Center speaker >
Removing the front net
1.
Remove the front net from the four holders marked c
that are fixing the front net.
2.
Pull out the front net toward the front while
disengaging the four joints marked c.
Note: When it is hard to remove the front net, insert a
minus driver, etc. in the place between the front
net and the front cover as shown in Fig.5 before
removing the front cover. Exercise care not to
damage the main body and the front cover
when inserting the minus driver. For this
purpose, insert the minus driver together with
cloth and the like.
Removing the center speaker (See Fig.6 )
1.
Remove the four screws marked F on the front of the
body.
2.
Pull out the center speaker toward the front and
disconnect the wire (black and black with white line)
from the speaker terminals.
1-16
(See Fig.3, 4)
Joints b
(See Fig.4)
Front cover
(See Fig.5, 6 )
Joints c
Holder c
D
D
D
Fig.3
Holder b
Holder b
Joints b
Fig.4
Front net
Fig.5
F
F
Fig.6
Front cover
D
Subwoofer
E
E
Joints c
Front cover
Holder c

Center speaker