Description Of Leds - Pentax VersaCam IC-360 User Manual

D. Description of LEDs
Data LED: This LED indicates the status of data transmission. After power is supplied, it is on for
the first 4-5 seconds and then it goes off. It blinks continuously when a user accesses the
VersaCam and is transmitting data.
Network Status LED: This LED indicates the status of the network. After power is supplied, it is
on for the first 1-2 seconds, and then it blinks every two seconds as long as the network is
connected.
1. Network Malfunction
• Network Status LED blinks once every 4 seconds
• Check if the Ethernet cable is connected properly, if the right Ethernet cable is being
used, or if the Network is working.
2. Software Malfunction
• Both LEDs are on and they blink 6 times rapidly every 10 seconds.
Contact Customer Support for assistance.
• After being on for one second, both LEDs blink 6 times rapidly. Then the network status
LED stays on and the Data LED stays off.
Re-installing the firmware can solve this problem. Contact Customer Support for
assistance.
Malfunction Indications
5
VersaCam IC-360 User's Guide