NEC ME401X User Manual page 117

To replace the filters:
Four filters are packaged with the replacement lamp, NP43LP.
Coase texture sponge filter: Large and small sizes (attached to the filter unit)
Fine texture sponge filter: Large and small sizes (attached to the filter cover)
The filter supplied with NP16LP is differed from ones' material supplied with NP43LP and that material is non-woven
material.
For reading the filter replacement procedures, replace the words "fine-texture sponge and coarse-texture sponge"
with "accordion soft and honeycomb hard" respectively.
NOTE:
• Replace all four filters at the same time.
• Before replacing the filters, wipe off dust and dirt from the projector cabinet.
• The projector is precision equipment. Keep out dust and dirt during filter replacement.
• Do not wash the filters with soap and water. Soap and water will damage the filter membrane.
• Put filters into place. Incorrect attachment of a filter may cause dust and dirt to get into the inside of the projector.
TIP:
While the material of filters attached to the projector at the time of purchase is different from the material of filters included with the
optional lamp, there is no difference in performance between these two types.
Before replacing the filters, replace the lamp. (→ page 103)
1. Push the catch to release the filter unit and pull it out.
2. Detach the filter cover from the filter unit.
The filter cover is fixed at six separate mounting points.
Bow the filter cover by pushing it slightly until it releases.
3. Replace the four (4) filters
1. Remove the filters, and then clean the filter unit and the filter
cover.
Filter unit
106
7. Maintenance
Notch
Filter cover