Safety Instructions - STA-RITE VERTICAL GRID DE FILTERS S7D75 Owner's Manual

READ AND FOLLOW SAFETY
INSTRUCTIONS!
This is the safety alert symbol. When you see this symbol on your filter
or in this manual, look for one of the following signal words and be alert
to the potential for personal injury.
warns about hazards that will cause death, serious personal in-
jury, or major property damage if ignored.
warns about hazards that can cause death, serious personal in-
jury, or major property damage if ignored.
warns about hazards that will or can cause minor personal injury
or property damage if ignored.
NOTICE indicates special instructions not related to hazards.
Carefully read and follow all safety instructions in this manual and on equip-
ment. Keep safety labels in good condition; replace if missing or damaged.
Incorrectly installed or tested equipment may fail, causing
severe injury or property damage. Read and follow instructions
in owner's manual when installing and operating equipment.
Have a trained pool professional perform all pressure tests.
1. Do not connect system to a high pressure or city water system.
2. Use equipment only in a pool or spa installation.
3. Trapped air in system can cause explosion. BE SURE all air is out of system
before operating or testing equipment.
Before pressure testing, make the following safety checks:
• Check all clamps, bolts, lids, and system accessories before testing.
• Release all air in system before testing.
• Tighten Sta-Rite pump trap lids to 30 ft. lbs. (4.1 kg-cm) torque for testing.
• Water pressure for test must be less than 25 PSI (172 kPa).
• Water Temperature for test must be less than 100
• Limit test to 24 hours. After test, visually check system to be sure it is ready
for operation. Remove pump trap lid and retighten hand tight only.
NOTICE: These parameters apply to Sta-Rite equipment only. For
non-Sta-Rite equipment, consult equipment manufacturer.
3
If filter clamps are
adjusted or removed
under pressure,
tank may explode,
causing severe injury or
major property damage.
Filter pumps require
hazardous voltage
which can shock, burn,
or cause death.
o o
F. (38 C).
BEFORE WORKING
ON FILTER:
1. Stop pump.
2. Open air release
valve.
3. Release all pressure
from system.
BEFORE WORKING
ON PUMP OR MOTOR
Disconnect power
to motor at main
circuit breaker.
Discharge motor
capacitor to ground.