Advertisement
III.
The indicator signal chart:
Signal
User Signals
Yellow、Green
Programming
Yellow、Red
Signals
Wiring diagram:
IV.
Note:
1. The suggested wire gauge is #22~26 AWG.
2. The varistor or diode must be connected across the lock terminal (electromagnet...)
operated by the device. The vartistor controls the overload produced by the strike coil
(EMP).
3. Using a Linear supply power recommended, to prevent power reduction at the card
reader.
Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-EASIPROX Ver. B Published on 2008.02.12
Yellow
Green
Red
Flashing
Green
Flashing
Red
Flashing
Flashing
Yellow
Flashing
Green
Blinking
Push Button
(N.O./Com.)
Condition
Power on, Stand-by
Lock relay active
Invalid Card
The memory is empty
Into the ADD CARDS MODE
Into the DELETE CARDS MODE
Into the CLEAR MEMORY MODE
Into the TIME ADJUST MODE
Clearing Memory
Power Supply
Electric Strike
(Fail-Secure Typical)
Electric magnet
(Fail-safe Typical)
Page: 2/ 4
Advertisement
