To Arm The System; To Disarm The System - Chrysler 300 2017 Owner's Manual

To Arm The System

Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicle's ignition is placed in the OFF
position (refer to Starting Procedures in Starting And
Operating for further information).
2. Perform one of the following methods to lock the
vehicle:
• Push lock on the interior power door lock switch with
the driver and/or passenger door open.
• Push the lock button on the exterior Passive Entry
Door Handle with a valid key fob available in the same
exterior zone (refer to Keyless Enter-N-Go — Passive
Entry in Things To Know Before Starting Your Ve-
hicle for further information).
• Push the lock button on the key fob.
3. If any doors are open, close them.

To Disarm The System

The vehicle security alarm can be disarmed using any of
the following methods:
• Push the unlock button on the key fob.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
• Grasp the Passive Entry Unlock Door Handle, if
equipped. Refer to "Keyless Enter-N-Go — Passive
Entry" in "Things To Know Before Starting Your Ve-
hicle" for further information.
• Push the Keyless Enter-N-Go ignition button (requires at
least one valid key fob in the vehicle).
NOTE:
• The driver's door key cylinder and the trunk button on
the key fob cannot arm or disarm the vehicle security
alarm.
• When the vehicle security alarm is armed, the interior
power door lock switches will not unlock the doors.
The vehicle security alarm is designed to protect your
vehicle. However, you can create conditions where the
system will give you a false alarm. If one of the previously
described arming sequences has occurred, the vehicle
security alarm will arm regardless of whether you are in
the vehicle or not. If you remain in the vehicle and open a
door, the alarm will sound. If this occurs, disarm the
vehicle security alarm.
If the vehicle security alarm is armed and the battery
becomes disconnected, the vehicle security alarm will
2