Using The Door Control - Chamberlain 8355 User Manual

Operation

Using the Door Control

SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door
opener, press the push bar until the garage door
opener activates (it may take up to 3 presses). Test the
door control by pressing the push bar, each press of
the push bar will activate the garage door opener.
MOTION-DETECTING CONTROL PANEL
LEARN Button
Light Button
MULTI-FUNCTION CONTROL PANEL
LEARN Button
LOCK Button
Command LED
Light Button
The control panel will vary depending on the garage door opener
model purchased.
Push Bar
Service LED
LOCK Button
Push Bar
Service LED
PUSH BAR
Press the push bar to open and close the door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener
lights on or off. When the lights are turned on they will
stay on until the LIGHT button is pressed again, or until
the garage door opener is activated. Once the garage
door opener is activated the lights will turn off after the
specifi ed period of time (the factory setting is 4-1/2
minutes). The LIGHT button will not control the lights
when the door is in motion. The duration of the light
timing can be adjusted using the door control, see
page 7.
The following features are accessible by lifting the
push bar:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry,
or MyQ ® accessories can be programmed to the garage
door opener by pressing the Learn button.
LOCK
The LOCK feature is designed to prevent activation of
the garage door opener from remote controls while still
allowing activation from the door control and keyless
entry. This feature is useful for added peace of mind
when the home is empty (i.e. vacation).
AUTOMATIC LIGHT
Motion Sensor (Motion-Detecting Control Panel)
Factory default is set to on. This feature automatically
turns on the garage door opener lights when motion
is sensed. The lights will come on for the set period of
time, then shut off. If using the garage door opener light
as a work light disable the motion sensor, otherwise
the light will turn off automatically if you are beyond the
range of the sensor.
Light Feature
The lights will turn on when someone enters through
the open garage door and the safety reversing sensor
infrared beam is broken.
MAINTENANCE ALERT SYSTEM (MAS)
This feature assists the homeowner in ensuring the
garage door opener system stays in good working
condition. When the garage door opener needs to be
serviced (approximately 4500 garage door opener
cycles) the command (yellow) and service (red) LEDs
will begin to alternately fl ash back and forth. The factory
setting for the MAS feature is off and can be activated
at time of installation. Contact your installing dealer for
service.
6