Aerial/Reconnection - Sanyo VHR-450 Instruction Manual

f
1
220-240 V -
%?!=
ANT Mm VIDEO
Aerial/RF connection
I
1
Unplug the aerial cable from your TV receiver
and reconnect it to the terminal marked
AERIAL IN
on the VCR,
H
Connect the aerial output cable (supplied) to
the AERIAL OUT terminal on the VCR.
H
Connect the other end of this aerial output
cable to the TV receiver,
A
Plug the power cord (supplied) into the VCR
power socket. Insert the plug straight and
firmly,
H
Insert the plug of this power cord into the wall
outlet,
Both video and audio (monaural) signals are fed
to the TV receiver and can be viewed by setting
the TV receiver to your preset video channel (see
page 11).
If your TV receiver has audio/video input terminals,
the following AV connection is also possible. The
advantage of this connection is a higher quality of
picture and sound during playback, The AV cable is
sold separately,
1 Connect the AV cable to the
AUDIOMDEO
OUT
terminals on the VCR.
n z Connect the other end of this AV cable to the
~ audio/video terminals on the TV receiver
Both video and audio (monaural) signals are fed
to the TV receiver and can be viewed by setting
the TV receiver to the AV mode.
When you play back a tape, set the"
the AV mode,
V receiver to
PREPARATION