Table of Contents
Advertisement
Seats
MEMORY SEAT SWITCH (if equipped)
To Program the driver's Seat Memory Position
1
2
3
4
Folding Seatbacks down
Returning rear seats to
upright position
1
2
5
3
1389818_14b_Mazda6_SSG_011113.indd 5
Turn the ignition switch off.
Adjust seat to desired position using the slide/tilt and recline switches.
Press and hold the memory seat SET button until a beep is heard.
Within 5 seconds:
• To program a memory seat button, press and hold memory button
1 or 2 until a beep sound is heard.
• To program a key, press and hold the key unlock button until a beep
sound is heard (two registered keys can be programmed).
Raise seatbacks until they lock into position.
Pull on the top of the seatbacks from inside
the vehicle to make sure they are locked.
Check that all seat belts are routed properly for passenger use.
NOTE:
Left rear seat shown.
Using remote handle:
1
Check that rear seats are clear.
2
Open the trunk and pull the
left and/or right side remote
handle lever(s).
3
Open a rear door and fold the
rear seat forward.
1/11/13 4:46 PM
Advertisement
Table of Contents
