Listening To The Radio; Battery Indicator - Roadstar TRA-800BT Instruction Manual

Portable bluetooth audio system with pll fm radio
Table of Contents

Advertisement

Available languages

Available languages

main supply of 230V ~ 50Hz when connected the external AC Adapter
(1). Connect the AC power adapter to the AC household main outlet,
the red LED will light up. Ensure that the voltage is as indicated on the
rating plate on the rear of the unit.
STATUS

BATTERY INDICATOR

FULLY CHARGED
NO LIGHT
CHARGING
RED LIGHT
LOW BATTERY
FLASHING RED LIGHT
NOTE: Charge the unit at least once a month to maintain the internal
battery integrity even when not in use.
SETTINGTHECORRECTTIME
1. Switch OFF the unit by pressing teh ON / OFF button (13).
2. Keep pressed the Scan / Clock button (7) for three seconds.
2. Press the TUNE+ or - (8) button to advance hour
3. Press shortly the Scan / Clock button (7) again.
3. Press the TUNE + or - (8) button to advance MINUTE until the
correct time is displayed.
4. Press shortly the Scan / Clock button (7) to complete the setting
operation.
English
3
4
LISTENINGTOTHERADIO
1. Press shortly the ON/OFF/AUTO (13) button to switch the Radio
2. Press 3 seconds the Scan / Clock button (7) to start the Radio auto-
3. Adjust the VOLUME Control (15) to a comfortable listening level.
5. To listen the desired Radio stations, short press MEMORY button (9)
6. To search manually a Radio station, when in RADIO mode press
6. To store manually the desired station in the memory, tune the
7. To listen the stored stations, refer to the chapter 5.
English
ON .
tuning function (the unit will store automatically the strongest
stations).
to enter in the stored station, then press TUNE + or - (8) to select
the desired Radio station.
the TUNE + or TUNE - (8) button sequentially until the desired
frequency is displayed. If the TUNE buttons are pressed for more
than 2 seconds, the Radio start searcing the station automathically.
station first then keep pressed the MEMORY button (9) three
seconds. The Display show the Memory number, then press the
TUNE + or - (8) to select the desired memory number, then press
shortly the MEMORY button (9) to store the station.

Advertisement

Table of Contents
loading

Table of Contents