Connecting The Terminal - Contec FX-DS540-APP User Manual

4 Setup Preparation

Connecting the Terminal

Use the following procedure to connect the terminal to the AP.
(1) Connect one end (D-SUB 9-pin male plug) of the RS-232C crossed-cable to the COM port on the AP.
The COM port is located on the rear panel.
FX-DS540-AP/APP
CO
M
CF1
POW
ER
WLI
NK
RS-232C
Cable
Figure 4.4 Connecting the Terminal
(2) Connect the other end (D-SUB 9-pin male plug) of the RS-232C cable to the COM port on the
terminal. If using a PC, connect to an unused COM port.
See Chapter 8 for the wiring diagram.
CAUTION
If the RS-232C cable does not match the socket on your terminal or PC, purchase a conversion
connector separately.
48
UTP
10/100
M
PC or Terminal
FX-DS540-AP, FX-DS540-APP