The Screen Image Is Off-Center Or There Are Odd Colors; The Operating System Warns That The Graphics Card Isn't Properly Configured; There Are Bus Address Or Interrupt Conflicts - AMD FirePro W8100 User Manual

rate, and color depth settings in the Settings and Monitor tabs in your Display
Properties dialog.
Caution:
Ensure that both the graphics card and monitor support the resolution and refresh
rates you select. Incompatible resolution/refresh rate selection may result in
monitor damage. Refer to your monitor's documentation for recommended
resolutions and refresh rates.

5.2.4 The screen image is off-center or there are odd colors.

Try adjusting the brightness, sharpness, contrast, and color balance controls of your
monitor.
Try adjusting the centering and positioning controls of your monitor to position the
picture on the screen.
Set the monitor's RGB inputs (and sync switches, if this option is available) to 75 Ohms,
with the sync set to external.
DFP monitor users: Make sure that the DVI plug of your monitor data cable is digital-
only (DVI-D), not integrated analog/digital (DVI-I). Refer to your monitor's
documentation and contact your supplier or the manufacturer of the DFP monitor for
information on how to obtain a suitable data cable plug.
If you need to use DisplayPort or Mini DisplayPort adapters other than the ones
included with your graphics card, make sure that you use AMD Eyefinity validated
dongles. For more information, see
eyefinity-dongles.aspx.
5.2.5 The operating system warns that the graphics card isn't properly
configured.
Make sure that the display resolution and refresh rate settings you have selected are
supported by the monitor you have connected.
Check the driver installation and make sure that all software is correctly loaded
corresponding to your operating system and applications.
Reinstall the drivers for your graphics card.

5.2.6 There are bus address or interrupt conflicts.

Make sure that the I/O and memory addresses reserved for the graphics board are
not used by other hardware devices. The integrated on-board VGA controller of your
AMD FirePro card uses the following addresses (hex):
I/O Address: Standard VGA I/O: 3B0-3DF
•
Memory Addresses: Video RAM: A000-BFFF, Video ROM: C000-C7FF
•
You cannot change the addresses of your AMD FirePro card. In case of an address
conflict, try to modify the I/O address of the add-on card that causes the conflict.
© 2014 Advanced Micro Devices Inc.
http://support.amd.com/us/eyefinity/Pages/
Reference 21
AMD FirePro™ W8100 Graphics Accelerator