Mounting Instructions - La Crosse Technology 330-2315 Instructional Manual

Mounting Instructions

TX233TH Temperature/Humidity Sensor
Option 1:
• Install one mounting screw into a wall.
• Place the transmitter onto the screw.
Option 2:
• Insert the mounting screw through the front of the
sensor and into the wall.
• Tighten the screw to snug (do not over tighten).
• Mount the temperature/humidity sensor on a
north-facing wall or in any well shaded location.
Sun will make it read high.
• Under an eave or deck rail is preferred.
• Be sure the outdoor sensor is mounted vertically to
drain moisture.
• The maximum wireless transmission range to the
weather station is over 330 feet (100 meters) in open
air, not including walls or floors.
TX233RW Multi-sensor
• Mount in an open area clear for 50 feet in all directions.
• Mount with the solar panel facing south, so the wind
direction is correct. See N, S, E W, embossed on the top
of the sensor.
• Use the bubble level on the top of the sensor to ensure
it is level, for accurate rainfall readings.
• The maximum wireless transmission range to the station
is over 330 feet (100 meters) in open air, not including
walls or trees.
• Cups should be on the top of the sensor.
• Attach to mounting surface with screws through the
mounting bracket.
• The sensor can be mounted from the bottom or from
the side.
Alternatively:
• Insert your own mounting pole into the sensor base.
• Tighten screws
• Mounting bracket would not be used.
330-2315 Professional Weather Station
Bubble
Level
Page | 15
Back
to
Top