Table of Contents
Advertisement
TNT Front Panel
1
2
3
INPUT
1
may occur to both units.
2
This switch is included so you can choose the appropriate setting for your instrument. Passive pickups
have a lower output, so the gain structure of the amplifier is modified to accommodate the different pickup
configurations.
PRE GAIN
3
This knob controls input level of the instrument.
BRIGHT SWITCH
4
This button provides a 10 dB boost to frequencies above 1KHz. To activate, depress the switch to its "IN"
position.
CONTOUR
5
CRUNCH SWITCH
6
This button engages a crunch effect, simulating the classic overdriven tube amp sound.
LOW
7
center point is flat. The center frequency is 50 Hz. -3 dB shelf corner frequency is 100Hz.
EQ BYPASS
8
This button removes the graphic equalizer from the audio chain. The "OUT" position of the switch bypasses the EQ, and
the amp will respond as if the graphic equalizer is set flat.
GRAPHIC EQUALIZER
9
These sliders provide precise tone control through the constant-Q, seven band equalizer. Each band may
be boosted or cut 15 dB.
HIGH
10
is flat and the frequency is 8 KHz. -3dB; the shelf corner frequency is 5 KHz.
COMPRESSOR
11
Rotating this knob clockwise will increase the amount of compression in the signal chain.
7
8
4
5
6
9
10
8
11
13
14
15
12
16
Hide quick links:
Advertisement
Table of Contents
