Deck Mechanism Disassembly; Holder Clamp; Clamp Assembly Disc; Plate Clamp - Sanyo dvw6100 Service Manual

DECK MECHANISM DISASSEMBLY

PLATE CLAMP

CLAMP HOLDER
DISC CLAMP ASSEMBLY

MAGNET CLAMP

UPPER CLAMP
(S1)
1. Holder Clamp (Fig. 5-1)
1) Release 2 Screws(S1).
2) Unhook 2 Locking Tabs(L1).
3) Lift up the Holder Clamp and then separate it from the
Base Main.

1-1. Clamp Assembly Disc

1) Place the Clamp Assembly Disc as Fig. (A)
2) Lift up the Clamp Assembly Disc in direction of
arrow(A).
3) Separate the Clamp Assembly Disc from the Holder
Clamp.
1-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise direction and
then lift up the Plate Clamp.
1-1-2. Magnet Clamp

1-1-3. Clamp Upper

(A)
(S1)
(Fig. A)
CLAMP HOLDER
(L1)
MAIN BASE
(L1)
CLAMP HOLDER
Fig. 5-1
DISC TRAY
EMERGENCY EJECT HOLE
LEVER
(B)
MAIN BASE
BOTTOM SIDE VIEW
2. Tray Disc (Fig. 5-2)
1) Insert and push a Driver in the emergency eject
hole(A) at the right side, or put the Driver on the
Lever(B) of the Gear Emergency and pull the Lever(B)
in direction of arrow so that the Tray Disc is ejected
about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
5-2
MAIN BASE
(A)
Fig. 5-2