Peavey EVH 5150 II Operating Manual page 24

Peavey electronics tube guitar amplifier operating guide
Table of Contents

Advertisement

Available languages

Available languages

POWER AMPLIFICATION
SECTION
RATED POWER AND LOAD:
120 W RMS into 16, 8, or 4 ohms
POWER @ CLIPPING:
(Typically @ 5% THD, 1 kHz, 120 V AC
line)
130 W RMS into 16, 8, or 4 ohms
(Bias must be reduced to measure.)
FREQUENCY RESPONSE:
+0, -3 dB, 50 Hz to 20 kHz @ 100 W
RMS into 8 ohms
HUM AND NOISE:
Greater than 75 dB below rated power
POWER AMP EQ:
Active Presence: +10 dB @ 2 kHz
Active Resonance: +10 dB @ cabinet
resonant frequency
POWER CONSUMPTION (Domestic):
400 watts 50/60 Hz, 120 V AC
(Domestic)
TUBE COMPLEMENT:
6-12AX7 preamp tubes
(1 for clean/crunch, 3 for Lead, 1 for
EFX and 1 phase splitter
4-6L6GC
5150
SPECIFICATIONS
PREAMP SECTION
The following specs are measured @
1 kHz with the controls preset as follows:
Low and High EQ @ 10
Mid EQ @ 0
Bright out
Lead and Rhythm Posts @ 10
Presence and Resonance @ 0 dB
Nominal levels with Pre Gains @ 5
Minimum levels with Pre Gains @ 10
PREAMP INPUT:
Impedance: Very high Z, 470K ohms
Lead Channel (with channel select in):
Nominal Input Level: -60 dBV,
1 mV RMS
Minimum Input Level: -76 dBV,
.15 mV RMS
Clean Channel (with channel select out):
Nominal Input Level: -30 dBV,
30 mV RMS
Minimum Input Level: -34 dBV,
20 mV RMS
Maximum Input Level: 0 dBV,
1.0 V RMS
(Subtract 24 dB with Crunch switch in.)
EFFECTS SEND:
Load Impedance: 47 k ohms or greater
Nominal Output: -10 dBV, 300 mV RMS
Features and specifications subject to change without notice.
II
®
EFFECTS RETURN:
PREAMP OUT:
REMOTE FOOTSWITCH:
SYSTEM HUM AND NOISE @
NOMINAL LEVEL (clean channel):
EQUALIZATION:
DIMENSIONS (H x W x D):
WEIGHT:
24
Impedance: Very High Z, 470 k ohms
Designed Level: -10 dBV, 300 mV RMS
Load Impedance: 47 k ohms or greater
Nominal Output: +10 dBV, 3 V RMS
Special 3-button unit with LED indicators
(supplied)
Channel select and reverb
(20 Hz to 20 kHz unweighted)
Greater than 63 dB below rated power
Custom Low, Mid, and High passive type EQ
Push Bright (Rhythm Channel only)
+6 dB @ 2 kHz
Push Crunch (Rhythm Channel only)
Increases gain
10" x 26.625" x 11.75"
(25.4 cm x 67.6 cm x 29.8 cm
48.3 lbs. (21.91 kg)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5150 ii

Table of Contents