Denon AVR-2803 Operating Instructions Manual page 15

3
Select the desired setting.
Variable:
The level can be adjusted freely using the buttons on the
remote control unit.
0 dB, -40 dB:
The output level is fixed at the set level and the volume
can no longer be adjusted.
4
Enter the setting.
At the "Zone2 Control" screen, select "Exit" and press the ENTER button.
The System Setup Menu reappears.
Setting the Ext. In Subwoofer Level
• Set the method of playback of the analog input signal connected to the Ext.In Subwoofer.
1
At the System Setup Menu select "Ext.In Subwoofer Level".
2
Switch to the Ext.In Subwoofer Level screen.
3
Select the desired setting.
Select according to the specifications of the player being used. Also refer to the player's
operating instructions.
+15dB (default) recommended. (0, +5, +10 and +15 can be selected.)
4
Enter the setting.
The System Setup Menu reappears.
Setting the Auto Surround Mode
The surround mode used at last for the three types of input signals shown below is stored in the memory, and
the signal is automatically played with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
q Analog and PCM 2-channel signals
w 2-channel signals of Dolby Digital, DTS or other multi-channel format
e Multi-channel signals of Dolby Digital, DTS or other multi-channel format
1
At the System Setup Menu select "Auto
Surround Mode" and press the ENTER button.
2
Select "ON" if you want to use the auto surround mode,
"OFF" if you do not want to use it.
3
Enter the setting.
The System Setup Menu reappears.
Setting the on screen display (OSD)
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
1
At the System Setup Menu select "On Screen
Display" and press the ENTER button.
2
Select "ON" or "OFF".
3
Enter the setting.
The System Setup Menu reappears.
ENGLISH
15