Advertisement
Available languages
Available languages
Advertisement
Table of Contents
Related Manuals for Peavey Ultra Plus Ultra Plus
Summary of Contents for Peavey Ultra Plus Ultra Plus
- Page 2 Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
-
Page 3: Front Panel Features
Dial in any degree of Clean, Crunch, or Dirty with the amp’s three channels and switch among them from the front panel or the footswitch. Peavey’s patented, three-way Resonance switch custom-tailors bottom end to your speaker cabinet and room environment. A half-power switch provides low-volume output tube saturation and ideal power for practice or small halls. - Page 4 RESONANCE SWITCH (3) Used to fine tune the low frequency range of the speaker enclosure by varying the damping factor of the amplifier between three presets. OUTPUT SWITCH (4) Allows selection of power amp output to be selected from full power (120 watts) to half power (60 watts output). POWER LED (5) Illuminates when AC power is being supplied to the amp.
- Page 5 If this occurs, position the Ground Switch to either positive or negative (+ or - ), or until the noise is minimized. Note: Should the noise problem continue, consult your Authorized Peavey dealer, the Peavey factory, or a qualified service technician. The Ground Switch is not functional on 220/240 volt models.
-
Page 6: Specifications
POWER AMPLIFIER SECTION Four 6L6GCs with 12AX7 driver Rated Power & Load: 120 W RMS into 16, 8, or 4 ohms Power @ Clipping: (typically @ 5% THD, 1 kHz, 120 VAC line) 130 W RMS into 16, 8, or 4 ohms (Bias must be reduced to measure) Frequency Response: +0, -2 dB 50 Hz to 20 kHz @ 100 W RMS into 8 ohms... - Page 8 Tone settings given are general and will vary according to the type of guitar, gauge type of the strings, the type of pickup, and even the type of pick. Personal preference, playing style, and type of music greatly contribute to desired tonality. Tone Settings ’...
- Page 9 El conmutador Resonance patentado de tres vias de Peavey tiene un diseno que armoniza perfectamente con la parte inferior del gabinete de su altavoz y el entorno de su habitation.
- Page 10 OUTPUT SWITCH (Conmutador de salida) (4) Permite seleccionar la potencia de salida del amplificador en una gama que va desde potencia tonal (120 watts) hasta potencia media (60 watts de salida). POWER LED (LED indicador de corriente) (5) Se ilumina cuando el amplificador recibe corriente alterna. STATUS LED (LED indicador de condich) (6) Se ilumina cuandeo el amplificador esta en la condition de espera (“standby”), indicando que el amplificador no esta en funcionamiento.
- Page 11 VOLUME (El volumen) (21) Controla el nivel de volumen del canal “clean”. LOW GAIN INPUT (Entrada de baja ganancia) (22) Se suministra para instrumentos que tienen una salida extremadamente alta, la cual puede causar la sobrecarga (distorsion) de la entrada de alta ganancia. HIGH GAIN INPUT (Entrada de ganancia alta) (23) Se usa para la mayoria de las guitarras electricas.
- Page 12 (croquant) et dirty (sale), et passez de I’un 2 I’autre g I’aide du panneau avant ou de la pedale. Le commutateur de rksonance & trois voies brevet6 par Peavey vous permet d’adapter la profondeur des basses ti votre haut-parleur et aux dimensions de la Salle.
- Page 13 POWER LED (DEL temoin de mise sous tension) (5) S’allume lorsque I’ampli recoit I’alimentation CA. STATUS LED (DEL temoin) (6) S’allume lorsque I’ampli est en mode d’attente << Standby )’ pour indiquer que I’amplificateur test pas op&ationnel. MASTER VOLUME (Principal volume) (7) Contr6le le niveau de volume global du systhme.
- Page 14 LOW GAIN INPUT (Entree faible gain) (22) Cette prise accepte les instruments a tres haut niveau de sortie qui causeraient de la saturation (distorsion) sur I’entree << High Gain >>. Si les deux entrees sont utilisees simultanement, les niveaux son alors equivalents (cc Low Gain >>). HIGH GAIN INPUT (Entree haut gain) (23) Cette prise s’utilise avec la plupart des guitares electriques.
-
Page 15: Technische Daten
3-Kanal-Verstarker, und schalten Sie von einem Kanal zum anderen, entweder am Schaltbord oder mit der FuOpedale. Der patentierte Peavey 3-Wege Resonanzschalter M3t sich am unteren Ende an den Lautsprecherstellplatz und an die r8umliche Umgebung anpassen. Ein Halbleistungsschalter garantiert fiir Rijhrenauslastung bei niedridger Lautsttirke und ideale Leistung fijr Proben oder kleinere Hallen. - Page 16 STATUS LED (Zustand kontrollampe) (6) Leuchtet auf, wenn der verst rker aut standby“ steht und zeight an, daB er nicht arbeitet. MASTER VOLUME (Hauptlautstiirke) (7) Regelt die Gesamtlautstarke des Get-&s. Wenn die gewunschte Balance der Clean, Crunch und Ultra-Kanale erreicht ist, kann die Gesamtlautstarke des Gerats mit diesem Hauptlautstarke regler angehoben oder abgesenkt werden.
- Page 17 Riickplatte: BESCHREIBUNG DER RUCKPLATTE IMPEDANCE SELECTOR SWITCH (Impedanz Wahlschalter) (24) Hiermit wird die entsprechende lautsprecher-impedanz eingestellt. Bei der verwendung von z.B. zwei lautsprechern gleicher impedanz sollte der schalter auf die halfte des werts eingestellt werden. Wenn angeschlossen werden, sollte der impedanz-wahlschalter auf 8 ohm eingestellt sein. SPEAKER OUTPUTS (Lautsprecherausgang) (25) l/4”...
- Page 18 If this product contains tubes or meters, Peavey warrants the tubes or meters contained in the product to be free from defects in material and workmanship for a period df ninety (90) days from date of purchase- PROVIDED, however, that this limited warranty is extended only to the onginal retail purchaser and subject conditions, exclusions.
-
Page 19: Important Safety Instructions
The user should not attempt to service this equipment. All service work should be done by a qualified service technician. This product should be used only with a cart or stand that is recommended by Peavey Electronics. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. - Page 20 Features and specifications subject to change without notice. Peavey Electronics Corporation 711 A Street / Meridian, MS 39301 / U.S.A. / (601) 483-5365 / Fax 486-l 278 01996 #80300294 Printed in U.S.A. 4/96...