Read and observe
and
›
To installcomplete detach the
pull out partially. The brackets
›
Set the crossbar so that the screws
›
Place the crossmember with the fixed part
the direction of arrow
.
2
›
Pull out part
of the cross member and place onto the right lashing eyelet
D
in arrow direction
.
3
›
Push the mounts
in the direction of arrows
B
›
Turn the screws
in the direction of arrow
A
›
Check how well the crossmember is fastened by pulling on it.
Removingis carried out in the reverse order.
Fig. 106
Install crossmember: Tighten the
screws
on page 82 first.
screws in the direction of arrows
A
are unlocked
» Fig.
105.
B
are pointing forward.
A
onto the left lashing eyelet in
C
until they
click» Fig.
4
up tothe latch.
5
Fitting/removing the bike rack
and
1
106.
Fig. 107 Fitting the bike rack
Read and observe
›
Toinstall, loosen screw
"carrier") in direction of arrow
›
Place the carrier of the crossmember in the direction of arrow
›
Hold part
of the carrier firmly and press on part
B
direction of arrow
›
Remove screw
A
›
Screw out screw
›
Place part
in the direction of arrow
E
the possible positions
›
Insert screw
and tighten in the direction of arrow
D
Removingis carried out in the reverse order.
CAUTION
The bike stowed in the rack must not touch either the boot lid or other vehicle
parts - there is a risk of damage to the vehicle occurring.
and
on page 82 first.
on the bicycle rack (hereinafter only referred to as
A
» Fig.
107.
1
.
3
in the direction of arrow
.
4
in the direction of arrow
and remove.
D
5
, depending on bike size, in one of
6
»
.
.
2
of the support in the
C
.
7
83
Transport of cargo