Table of Contents
Advertisement
Troubleshooting (continued)
Symptom
No picture
• The power cord, antenna
• The projection TV is not
No sound
• The volume level is too
Good picture
• The sound is muted.
• The broadcast signal
No sound
• The sound of the right
• There is local
Dotted lines or
stripes
• Broadcast signals are
Double images or
"ghosts"
• The antenna direction
• Use of a booster is
• The color level setting
No color
• The antenna direction
64
Additional Information
Possible cause
or VCR is not connected.
turned on.
low.
has a transmission
problem.
picture is selected
when TWIN pictures
are displayed.
interference from cars,
neon signs, hair dryers,
power generators, etc.
reflected by nearby
mountains or buildings.
needs adjustment.
inappropriate.
is too low.
needs adjustment.
Solutions
• Check the power cord, antenna and
the VCR connections.
• Press POWER on the remote.
• Press ! on the projection TV to turn
off the projection TV for about five
seconds, then turn it on again.
• Press VOL + to increase the volume
level.
• Press MUTING to cancel the muting.
• Press MTS until a better sound is
heard.
• Press
or
.
• Do not use a hair dryer or other
equipment near the projection TV.
• Adjust the antenna direction for
minimum interference. Contact a
Sony dealer for advice.
• Use a highly directional antenna.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
• Turn off or disconnect the booster if it
is in use.
• Display the "PICTURE" menu and select
"ADJUST" of "PICTURE MODE", then
adjust the "COLOR" level.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
Page
6
15
16
16
16
30
25
–
–
–
–
–
50
–
Advertisement
Table of Contents
