Inserting Media; Charging A Device; Inserting A Disc; Connecting A Usb Device - Panasonic SC-RS50 Owner's Manual

Inserting media

Inserting a disc

1
Press [<] on this unit to open the disc tray.
2
Put in a disc with the label facing up.
3
Press [<] again to close the disc tray.

Connecting a USB device

Insert the USB device directly. Do not use any USB
extension cable.
≥ Please disconnect the USB device if you finish using.
≥ Before removing the USB device, select a source other than
"USB".
≥ When moving this unit, be sure to remove all media and turn this unit to standby mode.
6
RQT0A75

Charging a device

Charging starts when a device (rated value: DC 5 V/
1.5 A) is connected to the USB port of this unit.
1
Turn the unit on.
2
Select a source other than "USB".
3
Connect a device.
≥ Confirm from the screen of the connected device, etc. to
make sure charging has started.
≥ After the device has started charging, you can turn the
unit to standby mode.
– When charging a depleted device, do not turn the unit
to standby mode until the device becomes
operational.
To the compatible device
≥ A cable compatible with your device is required. Use the
cable that comes with your device.
≥ Even if you connect a cable compatible with the USB port of
this unit, your device may not be charged. In that case, use
the charger that comes with the device.
≥ Depending on your device, using other chargers may not
work. Check the operating instructions of your device before
use.
≥ Do not connect a device with a rated value higher than 5 V/
1.5 A to this unit.
≥ To check if charging is complete, look at the screen of the
connected device, etc.
≥ Once fully charged, remove the USB cable from the USB
port.
USB cable
(not supplied)