Mounting The Remote Controller To The Wall; Mounting The Remote Controller To The Switch Box - Rinnai WF-100W_EU User Manual

3. Mounting the Remote Controller.
1) Mounting the Remote Controller to
the Wall
Make a hole for the hole plug (ø6.0x
depth 35~40mm) on the wall and then,
insert the hole plug.
Drill a hole to be vertical to the wall.
Do not exert too much force. Otherwise,
it could damage the remote controller.
Do not excessively fasten the screw.
Otherwise, it could deform the bracket,
which would make the installation hard.
When the power line of the remote
controller is taken out through the
bottom of the remote controller,
it should be taken out in between the
bottom of the bracket and the furrow
on the remote controller.
2) Mounting the Remote Controller to
the Switch Box
After separating the bracket from the
remote controller and then, affix the
bracket with the flat headed screw,
comes with the boiler.
Connect the power line of the remote
controller and then, put the remote
controller into the bracket.
Affix the bracket securely to the wall
with the flat headed screw. If screws
other than the flat headed screw are
used, it might not be possible to mount
the remote controller.
52
Flat headed screw
Bracket for affixing the remote controller
Flat headed screw
Cement
wall
Hole plug