Table of Contents
Advertisement
Battery Installation (Fig.2)
1. Place two alkaline AAA batteries in the
Headphone's battery compartment making sure
that the battery polarity is correct.
2. Replace the battery cover.
Fig. 2
HEADPHONE OPERATION
IMPORTANT: To prevent possible ear damage,
Read the following Carefully!
1. Turn the headphone volume down before turning
on the power. Turn on the headphone power then
increase the headphone volume to a comfortable
level.
2. Before switching between channels A and B,
remove headphones and turn the volume down
because the signal of channel could be louder
than the other.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
Product Specifications:
Operating range : up to 25 Ft.
Frequency Response : 35 – 18,000Hz
S/N ratio : 60 dB
Channel Separation : 45 dB
Optional Accessories
Wired Headphone
There are two 1/8" headphone jacks on the VOH684
that can be used with any standard stereo
headphones. The jack, TV EAR, is used to listen to
the video program audio. The audio volume is
controlled by the TV VOLUME up/down buttons. The
jack, RADIO EAR, is used to listen to the FM
broadcast.
The audio volume is controlled by the
RADIO VOLUME up/down buttons. Remove the
protective plastic cover to access the jacks.
Remember to replace the cover when the jacks are
not in use.
-13-
128-6116
13 of 16
Advertisement
Table of Contents
