Brookstone flightforce User Manual

Stunt drone
Hide thumbs Also See for flightforce:

Advertisement

FLIGHT FORCE
for ages
14
+
STUNT DRONE

Advertisement

Table of Contents
loading

Summary of Contents for Brookstone flightforce

  • Page 1 FLIGHT FORCE ™ for ages STUNT DRONE...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Warnings and Cautions ........1 FCC Information .
  • Page 3 CAUTION • TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. THERE ARE NO SERVICEABLE PARTS INSIDE. • TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. The lightning flash with arrow-head symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage”...
  • Page 4 DRONE WARNINGS: 1. The Drone is designed for INDOOR or OUTDOOR flight. 2. The Drone’s blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the Drone to reduce the risk of getting into the flight path and always maintain visual contact with the Drone while flying.
  • Page 5 CAUTION: DO NOT ATTEMPT TO FLY THE DRONE IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND MAY CAUSE BODILY HARM. WARNING DO NOT FLY THE DRONE IN FOUL WEATHER! WARNING! • Choking/Cutting Hazard. Small Parts/Sharp Rotor Blades. •...
  • Page 6 BATTERY WARNINGS RECHARGEABLE BATTERY (DRONE): This device contains a removable Lithium-Polymer battery. The included charger is built specifically for the Stunt Drone Li-Poly battery. Do not use it to charge any other battery. The battery must be recycled or disposed of properly. Contact your local waste management office for information on battery recycling or disposal.
  • Page 7 • Exhausted batteries should be removed immediately and must be recycled or disposed of properly according to state or local government ordinances and regulations. • The supply terminals are not to be short-circuited. • Only batteries of the same or equivalent type as recommended are to be used.
  • Page 8 WARNING 1. Close supervision is necessary when this appliance/product is used by or near children or mentally disabled individuals. 2. Use this unit only for its intended use as described in this manual. 3. Unplug this unit during lightning storms or when unused for long periods of time.
  • Page 9 9. Do not overload the electrical outlet. Use only the power source as indicated. 10. Do not carry this unit by its cord or use the cord as a handle. 11. Never operate this unit if it has a damaged cord or plug, if it is not working properly, or if it has been dropped or damaged, or dropped into water.
  • Page 10: Fcc Information

    FCC INFORMATION Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules.
  • Page 11 • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
  • Page 12: Location Of Parts And Controls

    LOCATION OF PARTS AND CONTROLS 1. Blade 5. Motor 2. Upper Shell 6. LED Indicator 3. Bottom Shell 7. Guard Frame 4. Battery Cover...
  • Page 13 LOCATION OF PARTS AND CONTROLS 1. Flight Mode 5. Flip 180° 2. Trim Forward/Reverse 6. ON OFF B/M (Beginner Mode) 3. Power Indicator LED 7. HI/LOW Speed 4. Trim Left/Right ASCEND FORWARD TURN RIGHT TURN LEFT SLIDE LEFT SLIDE RIGHT DESCEND BACKWARD...
  • Page 14 INSTALL BATTERIES IN THE CONTROLLER 1. On the controller, set the on/off switch to OFF. 2. Use a screwdriver to open the battery compartment. 3. Insert four AAA batteries (not included), matching the polarities marked inside. Use alkaline batteries for optimal performance. During play, if the controller’s LED flashes, replace the batteries.
  • Page 15 CALIBRATING THE DRONE 1. After pairing, move the throttle backward and the steering forward at the same time. Hold this until the drone’s two LEDs flash about three seconds. 2. When LEDs stop flashing, the calibration is complete. After calibration, the drone should fly smoothly and hover in the air; if not, trim your drone to fine-tune.
  • Page 16 GET READY TO FLY 1. Open the battery cover at rear of the drone and plug in the battery. The drone’s head red LED flashes. 2. Place the drone on the level ground. 3. Set the controller switch to ON. Controller LED flashes and beeps. 4.
  • Page 17 FLY YOUR DRONE 1. Once paired, press the steering control (right joystick) down to switch between high speed (double beep) and normal speed (single beep). 2. For beginners, use normal speed or beginner mode (B/M) to fly. In beginner mode, ascent and descent will be slow. Operators can move up and down while flying the drone slowly.
  • Page 18 FLIGHT MODE In this mode, there is no difference between the head and tail. Press “FLIGHT MODE’’ button so that the drone’s head and tail direction will not matter.
  • Page 19 FLIP STUNTS 1. Press the 180° button, the controller will beep. 2. Move steering control to perform flip. •Front flip: move lever forward •Back flip: move lever backward •Left/right flip: move lever left/right 3. To exit stunt mode without a flip, press the flip button again before moving the steering control.
  • Page 20: Replacing The Propeller Blades

    REPLACING THE PROPELLER BLADES The Stunt Drone's propeller system is a precision instrument that may need repair or replacement for optimal flight function. Crash landing from high-speed aerial flights may cause damage to your Stunt Drone's propellers. 1. Before making any repairs, turn off the power and disconnect the battery.
  • Page 21 • Make sure the drone is within the control range (130 ft./40 m) and in line of sight. Drone difficult to control • The throttle control is very senstive. Use small, fine movements to control. • Practice in B/M (Beginner Mode). •...
  • Page 22: Care And Maintenance

    CARE AND MAINTENANCE • Always remove the batteries from the controller when it will not be used for an extended period of time. • To clean, gently wipe the drone and controller with a clean damp cloth. • Parental guidance recommended when installing or replacing the batteries.
  • Page 23: Warranty

    (“Warranty Period”). If a defect arises and a valid claim is received within the Warranty Period, at its option, Brookstone will either 1) repair the defect at no charge, using new or refurbished replacement parts, or 2) replace...
  • Page 24 Brookstone may provide their own warranties to the purchaser, but Brookstone, in so far as permitted by law, provides these products “as is.” This warranty does not apply to: a) damage caused by failure to follow instructions relating to product’s use or the installation of components; b) damage caused by accident, abuse, misuse, fire, floods, earthquake or other external causes;...
  • Page 25 Find thousands more great ideas online 317889 Merrimack, New Hampshire, USA 03054 • 800-846-3000 • Brookstone.com...

Table of Contents