Operating Procedure For Pcpro - NEC Univerge SV8500 Operation And Maintenance Manual

When this count is large in number, wrong password may be assigned to either the TP side or SIP ter-
Note 4:
minal side. When the TP side or the SIP terminal side of password is corrected, this situation does not
occur. For more information of TP side password, refer to SIP terminal Accommodation [S-146] in
Data Programming Guide (Windows)-SIP. For SIP terminal side, refer to the operation manual for
each terminal.
This is the number of situations recognized as no vacancies in bandwidth at SP. When this count is large
Note 5:
in number, additional vacant speech channels are needed. The speech channels are added by ASSDN/
ASSDL command. Up to 1200 speech channels are provided.

9.2 Operating Procedure for PCPro

(1) Procedure for Set-up and Start
The procedure to set up and start the traffic measurement is as follows:
STEP 1 By using the ASYD/ASYDN command, assign the necessary system data as follows:
When performing traffic measurement on a node basis:
- ASYD
SYS1, INDEX 8 (Number of Tenants)
SYS1, INDEX 9 (Number of Attendant Consoles)
SYS1, INDEX 47, b0 (Unit of Traffic Measurement): 0/1 = CCS/Erlang
SYS1, INDEX 47, b7 (Traffic Measurement Service): 0/1 = Out/In Service Assign "1."
When performing traffic measurement on a network basis (via TCP/IP):
- ASYDN
SYS1, INDEX 8 (Number of Tenants)
SYS1, INDEX 9 (Number of Attendant Consoles)
SYS1, INDEX 47, b0 (Unit of Traffic Measurement): 0/1 = CCS/Erlang
SYS1, INDEX 47, b7 (Traffic Measurement Service): 0/1 = Out/In Service Assign "1."
When Station Peg Count, ATTCON Peg Count or ATT Answer Peg Count is performed.
Note 1:
When Terminal Traffic Measurement, Route Traffic Measurement or Connection Route Traffic
Note 2:
Measurement is performed.
STEP 2 By using the ATRF/ATRFN command, assign the traffic measurement programs as follows:
When performing traffic measurement on a node basis:
- ATRF
Note 4
Assign traffic measurement TYPE
Time (HOUR/MINUTE), etc. For more information, see the ATRF command.
When performing traffic measurement on a network basis (via TCP/IP):
- ATRFN
Note 4
Assign traffic measurement TYPE
Time (HOUR/MINUTE), etc. For more information, see the ATRFN command.
Select one measurement TYPE at a time. If two or more measurement TYPEs are needed, repeat the
Note 3:
same steps, following the entry of this command.
CHAPTER 2
Note 1
Note 1
Note 1
Note 1
, PORT number used, and the output INTERVAL and
Note 3
, PORT number used, and the output INTERVAL and
Note 3
– 134 –
Operations of SV8500 Server
Note 2
Note 2
Note 2
Note 2