Special Tools; Personal Computer (Pc); Alarm Monitoring And Inspection - Alcatel MDR-8000 User Manual

SPECIAL TOOLS

5.3
Refer to Table 5-1 for special tools required for maintenance. Similar tools can be substi-
tuted for those recommended; however, before substitution, check the minimum parameters.
TOOL
Torque Limiting Screwdriver
Briggs-Weaver PN 8370-01880
#2 Phillips Bit Extension
Briggs-Weaver PN 8528-27370
Torque Wrench,
Utica Model CHA5 w/OP-102
5.4

PERSONAL COMPUTER (PC)

The PC is an on-line maintenance and troubleshooting tool. See Figure 5-2. Connect the
RS-232 interface cable between USI connector on controller and the PC.

ALARM MONITORING AND INSPECTION

5.5
Perform the following checks whenever a station is entered:
1
Verify that no alarms are lighted; only the green status indicators should be
lighted.
2
Momentarily press LAMP TEST switch. Verify all indicators light.
Keeping records of errors and alarm history can be an aid to system trouble-
shooting.
The local status alarms screen displays the alarms of the radio to which the
USI is connected, either physically or addressed via the ELMC.
3
Using the USI computer, check local alarms on the Local Status Alarms
screen.
5-4
Table 5-1 Special Tools Required
ESSENTIAL CHARACTERISTICS
#2 Phillips, 19 in-lb
(for use with torque limiting screw-
driver)
5/16 in., 7-to-9 in-lb, sensing type
Note
Note
USED ON
DS1/E1, DS3, OC3
DS1/E1, DS3, OC3
DS1/E1, DS3, OC3