Kenwood TH-25A Instruction Manual page 8

LCD display
(jJ)
EI
+ (European version:
EI _ )
Displays the selected transmitter offset direction.
When neither indicator is ON the transceiver is in the
Simplex mode. When both indicators are ON the
transceiver is in the Split Channel mode.
When a indicator flashes the transceiver is in the
Reverse function.
@ Frequency display
Displays the operating frequency to the nearest kHz.
TH-55AT/55E: Displays the operating frequency from
10 MHz digit.
raBBBB
L ______
~-
_______ 1
(jji Busy indicator
ON whenever there is a Signal present strong enough
to open the squelch. or when the squelch is not ac-
tivated. and the CTCSS key is OFF.
@ •••••••••• -
Used to indicate the relative receive signal strength, or
as an indication of the battery voltage level during
transmit.
@ MHz indicator
This indicator flashes during MHz tuning steps.
@ MHz dot
This indicator flashes during scan operations.
@ VFO indicator
This indicator lights during VFO operation.
@ Hz dot
This indicator lights during
cress
frequency selec-
tion, and is used to show the 1 Hz digit.
TH-55AT/55E: Additionally ON when the Battery
Saver and Automatic Power Off function have been
cancelled.
(jji 5 kHz tuning step indicator
This indicator lights during VFO operation when tuning
in 5 kHz steps.
@ 500 Hz dot (TH-25E/TH-45E only)
This indicator show 500 Hz.
@
T indicator
T his indicator is ON when the Tone function is active.
@ CTCSS indicator
T his indicator is ON when the
CTeSS
function is ac-
tive.
...(1
@ T
. ALT indicator ~
This indicator is ON when the Tone alert system is ac-
tive. The indicator will flash when a signal is received .
@ Memory channel indicator
T his indicator is used to show the selected memory
channel number.
@ Memory indicator
This indicator lights during Memory Recall mode, and
flashes during Memory entry.
9