Table of Contents
Advertisement
–
+
ELEC
4
1
5
1
3
6
2
REMOTE CONTROL SYSTEM
6
2
3
1
5
4
Replacing of the transmitter battery
CAUTION:
• Do not allow any water, dust, or dirt to
enter the remote control transmitter case
when replacing the battery.
• Make sure that no foreign material is
trapped between the upper case and
lower case of the remote control transmit-
ter during assembly.
1. Remove:
• Cover
NOTE:
Loosen the transmitter cover screws in the
sequence shown.
2. Install:
• Battery 1
NOTE:
Install the battery (CR2016) with the positive
side facing down.
3. Install:
• Cover
NOTE:
Tighten the transmitter cover screws in the
sequence shown.
Transmitter cover screw:
0.1 N • m
(0.01 kgf • m, 0.07 ft • lb)
7-56
E
Advertisement
Table of Contents
