Adjusting The Feet; Electrical Connection; First Use - Beko DCU 9330 User Manual

periodically draining the water collected in
the water tank.
Please refer to the detailed instructions
supplied with the accessories pack.
Connecting the water drain hose;
1. Remove the hose on the machine by
pulling it out from its end. Do not use
any tools to take out the hose.
2. Connect the special drain hose supplied
with the machine to the pipe fitting.
3. The other end of the drain hose can be
directly connected to the wastewater
drain or to the washbasin. The fitting
must always be secured in all types of
connections. Your house may be flooded
if the hose gets out of its housing during
water discharge.
Important:
• The hose should be attached to a height
of maximum 100 cm.
• You must be careful not the pinch or
bend the hose.
• The end of the hose should not be bent,
it should not be stepped on and it must
not be folded between the drain and the
machine.

Adjusting the feet

In order to ensure that your machine
operates more silently and vibration-free, it
must stand level and balanced on its feet.
Balance the machine by adjusting the feet.
Rotate the feet to adjust until the machine
stands level and firmly.
C Never unscrew the adjustable feet from
their housings.

Electrical connection

Connect the machine to a grounded outlet
protected by a fuse of suitable capacity as
stated in the technical specifications table.
Our company shall not be liable for any
damages that will arise when the machine
is used on a circuit without grounding.
• Connection must comply with national
regulations.
• If the current value of the fuse or
breaker in the house is less than 16
Amps, have a qualified electrician install
a 16 Amp fuse.
• Power cable plug must be within easy
reach after installation.
• The voltage and allowed fuse or
breaker protection are specified in the
"Technical Specifications" section.
• The specified voltage must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
• The main fuse and switches must have
a contact distance of minimum 3 mm.
BDamaged power cable must only be
replaced by a qualified electrician.
BIf the product is faulty, it must not be
operated unless it is repaired! There is
the risk of electric shock!

First use

• To have the product ready for operation
before calling the authorised service
agent, make sure that its location
and power supply installations are
appropriate. If they are not, call a
qualified electrician to have any
necessary arrangements carried out.
• Make sure that the power connections
of the product are in accordance
with the instructions given in relevant
chapters of this manual.
63 EN