Installation Procedure (For One Of Ptu Installed Machine) - Ricoh D127 Service Manual

2.5.2 INSTALLATION PROCEDURE (FOR ONE OF PTU INSTALLED
MACHINE)

Unplug the main machine's power cord before starting the following procedure.
1. Remove the paper tray unit from the copier if it is already installed.
2. Remove the rear cover [1] from the paper tray unit (

Right screw on the picture is a shoulder screw.
3. Fasten the heater [2] (
4. Put the clamps (Small) [3] in the holes
5. Joint the connector [4] to the heater harness (Short) [5].
6. Pass the heater harness (Short) [5] through the hole [6].
7. Attach the heater harness (Short) through the clamps as shown.
SM
x 2).
2-17
Paper Tray Unit Heater
x 2).
D127/D128