Environmental Protection; Technical Specifications; Tips And Tricks - Metabo BDE 1100 Operating Instructions Manual

7520.book Seite 10 Montag, 22. Mai 2006 3:14 15
ENG ENGLISH
8.7 Removing the chuck
Geared chuck (2)
Undo the locking screw. Caution left-handed
thread !
Hold the drill spindle tight with a spanner. With a
light blow from a rubber hammer release the chuck
from the inserted chuck key and unscrew it.
f

9 Tips and Tricks

In the case of deep bores pull the drill bit out of the
bore from time to time in order to remove the stone
dust or shavings.
For thread tapping, slightly oil the tap. Select low
speed and . Start cutting in clockwise
direction, stop and turn out in counter-clockwise
direction.
f
10 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
For complete range of accessories, see
www.metabo.com or the main catalogue.
11 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
10
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
power tool.

12 Environmental Protection

Metabo's packaging can be 100% recycled.
Worn out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national legal
systems, used power tools must be collected
separately and handed in for environmentally
compatible recycling.

13 Technical Specifications

Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
P = Rated power consumption
1
P = Power output
2
n = No load speed
1
n = On load speed
2
ø max = Max. solid drill diameter
b = Chuck capacity
G = Spindle thread
m = Weight
D = Spindle collar diameter
Typical A-weighted sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Unsafe
pA WA
During operation the noise level can exceed
85 dB(A).
Wear ear muffs !
ahw = typical weighted acceleration in the
hand-arm area
Measured values determined in conformity with
EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).