Managing Configuration Files; Overview; Configuration Types - HP 830 Series Configuration Manual

Managing configuration files

You can use the CLI or the BootWare menus to manage configuration files. This chapter only describes
managing configuration files from the CLI.

Overview

A configuration file saves configurations as a set of text commands. You can save the running
configuration to a configuration file so the configuration takes effect after you reboot the device. You can
also back up the configuration file on to a host and download the file to the device as needed.

Configuration types

The device has the following types of configurations: factory defaults, startup configuration, and running
configuration.
Factory defaults
The device is shipped with some basic settings called "factory defaults." These default settings make sure
the device can start up and run normally when it has no configuration file or when the configuration file
is corrupted.
Factory defaults vary with device models and might differ from the default settings of commands.
To view factory defaults, use the display current-configuration command the first time you start up the
device before making any configuration.
Startup configuration
The device uses startup configuration to configure software features during startup. After the device starts
up, you can specify a different configuration file to be loaded at the next startup. This configuration file
is called the "next-startup configuration file." The configuration file that has been loaded is called the
"current startup configuration file."
You can view the current startup configuration in either of the following ways:
Execute the display startup command. To view detailed file contents, use the more command.
•
After the device reboots, execute the display current-configuration command before making any
•
configuration changes.
Running configuration
Running configuration is stored in a volatile storage medium and takes effect while the device is
operating. It includes startup settings that have not been changed and new settings you have made.
A new setting takes effect immediately after it is made but must be saved to a configuration file to survive
a reboot.
To view the running configuration, use the display current-configuration command.
79