Replacing Bulbs; Installing The Wheel; Removing High/Low Beam Headlight Bulbs - Volvo S40 2001 Owner's Manual

2001 Volvo S40 & V40

Installing the wheel

Clean the contact surfaces on the wheel and hub. Lift the wheel and place it on the hub. Install the wheel
bolts crosswise and tighten until snug by turning clockwise. Lower the vehicle to the ground and
alternately tighten the bolts to 81 ft. lbs. (110 Nm). Install the wheel cover (where applicable).
pg. 87 Replacing bulbs
Remove cover

Removing high/low beam headlight bulbs

· Your car is fitted with separate high and low beam bulbs.
· Switch off the lights and remove the ignition key.
· Open the hood.
· Pull off the rubber cover from the rear of the bulb unit to be replaced.
· Release the retaining spring and withdraw the connector/bulb from the headlight unit. Pull the bulb out
of the connector.
NOTE: Never touch the glass of a bulb with your fingers: this could leave traces of grease or oil on the
glass which then evaporate and may damage the reflector.
pg. 88 Replacing bulbs
file:///K|/ownersdocs/2001/2001_SV40/01sv40_06a.htm (6 of 12)12/30/2006 3:49:22 PM