Advertisement
operating your refrigerator
DISASSEMBLY AND CLEAN THE PARTS
4. Disassembly of the humidifier
• Pull the concave handle on the humidifier's cover.
• Loosen the fasteners at left and right sides of the cover
to take out the cover.
• Clean inside of the humidifier's water container and the
upper cover, and wipe with a dry and soft cloth.
• After clean, reassemble the humidifier and then put it in
the Refrigerator.
• When right side angle of the "△" mark on the humidifier's
water container is between the two transverse lines under the "O"mark of the right baffle
plate, it means water container of the humidifier has been set in place.
You're recommended to clean the humidifier once each week.
Note:
When the humidifier is put into the Refrigerator, surface of its upper cover should
align with that of its near clapboard.
You only need to clean inside of the humidifier's water container. While cleaning,
don't put it into water or under a tap for rinsing directly; otherwise, water will
WARNING
enter its inside and connectors, and the humidifier may not work properly.
• After cleaning, please check if there is water stain on the connectors at back of the
water container. If so, wipe it or dry it naturally before putting it into the Refrigerator.
• You'd better not use detergent while cleaning. If unavoidable, rinse it so as to avoid
residual detergent.
• The residual detergent will affect the atomization amount when the vibrator is working.
• Soft tools (i.e. hair brush) may be used while cleaning, but don't use sharp and hard
tools; otherwise, surface of the vibrator at bottom of the water container may be
scratched.
5. Disassembly and clean of the vegetable & fruit compartment
• Take out the small drawer before disassembling;
• Pull its door and big drawer to full extension, lift exterior of the whole
drawer and pull it out lightly, lift the white plastic drawer and take it out;
• Rinse the white plastic drawer and the small drawer, and then wipe
with a dry and soft cloth;
• Assemble the plastic drawer and the small drawer respectively in
reverse order.
If the whole drawer is taken out, please refer to installation method
Note:
of the lower drawer of freezer.
6. Disassembly and clean of the ice making
compartment
• Pull out the drawer of the ice making compartment to full extension;
• Lift rear end of the drawer, move 20~30mm towards rear end of the
Refrigerator, and then lift the front end to take out the drawer;
• Rinse the temperature-variable compartment's drawer, wipe it with a soft
cloth;
• Assemble the temperature-variable compartment's drawer in reverse
order.
Don't disassemble or clean the automatic ice maker.
Note:
22_ operating
Advertisement
