Table of Contents
Advertisement
CSW45
Cleaning the Interior Components
1. Unplug ice maker or disconnect power.
2. Open the storage bin door and remove any ice
that is in the bin.
3. Remove the drain cap from the water pan and
drain thoroughly. Replace the drain cap.
4. Remove the three screws that hold the cutter grid
cover in place.
5. Unplug the wiring harness from the left side of the
cutter grid.
1
2
1. Cutter Grid Cover
2. Screws
6. Unplug the ice level sensor from the right side of
the cutter grid. Pull the ice level sensor down and
forward away from the cutter grid.
7. Remove the right-hand screw and loosen the
left-hand screw. Lift the cutter grid up and out and
over the left-hand screw.
www.spaequip.net
Electrical Shock Hazard
Failure to follow these
instructions can result in
death, fire, or electrical
shock.
Disconnect power before
servicing.
Replace all panels before
operating.
NOTE: Make sure the plastic spacer from the
right-hand side of the cutter grid bracket stays with
the cutter grid.
1
2
3
1. Cutter Grid Harness
2. Screw
3. Cutter Grid
4. Ice Level Sensor Harness
5. Plastic Spacer
6. Screw
July 1999
p: 707.737.1100
Page 14
Product Code: AHT9KCSW45A1A
Page 5 of 15
4
5
6
Advertisement
Table of Contents
