Using The Sleep Timer - Sony STR-GA9ESG Operating Instructions Manual

Basic Operations
To control the recorder (when not recording)
Click RECORDER. "RECORDER" becomes the source
component and you can use the RECORDER controls to
rewind and playback the recording (etc.).
Click PLAYER to return control to the original source
component.
To monitor the recorded sound when recording to a 3-
head cassette deck
1 Click EXIT.
2 Click FUNCTION in the main menu.
3 Click TAPE.
To stop recording
Click on p of the recording unit.
To return to the main menu.
Click EXIT.
Notes
• There is no sound output from the recording component
even though all the buttons on the recording unit's control
panel are operational.
• If you click RECORDER during recording, the source
being recorded will be cut off.
• If you leave the REC EDIT menu by clicking FUNCTION,
SOUND, or EXIT, recording continues, but control returns
to the PLAYER side, even if you previously clicked
RECORDER.
• If you open the FUNCTION SELECT menu and click
another program source while recording, the newly
selected program source will be recorded.
• Some cassette decks require that you press the r REC and
( buttons simultaneously to start recording. To perform
one-button from the on-screen display, be sure to record
the recording signal as shown in steps 1 to 7 of
"Registering non-Sony audio/video equipment" (pages 18
to 20) for both Sony and non-Sony products.
• Sound input through the TAPE connectors on the rear
panel cannot be recorded on a recording unit.
• When you record on a DAT or MD connected to the DAT/
MD REC OUT jacks, sound adjustments do not effect the
recording.
• Sound input through the 5.1 INPUT connectors on the rear
panel cannot be recorded on a recording unit.
28

Using the Sleep Timer

You can set the receiver to turn off automatically at a
time you specify.
1
Click FUNCTION in the main menu.
2
Click SLEEP.
FUNCTION SELECT
VIDEO 1
VIDEO 2
VIDEO 3
L D
TV / DBS
MACRO 1
SLEEP
3
Click TIMER repeatedly to select the length of the
sleep timer. The timer changes as shown below:
SLEEP TIMER SETTING
HOUR
2 :
SLEEP
RETURN
n 2:00:00 n 1:30:00n 1:00:00 n 0:30:00 n OFF
You can also freely specify the time
Click + or – to change the sleep time in 1 minute
intervals. You can specify up to 5 hours.
To return to the main menu
Click EXIT.
To go to the previous menu
Click RETURN.
When the sleep timer is set
"SLEEP" appears in the upper left corner of the main menu.
FUNCTION
SLEEP
You can check the time remaining before the
receiver turns off
Click FUNCTION, then click SLEEP. The remaining
time appears in the on-screen display.
DAT/MD
CD
TUNER
PHONO
TAPE
MACRO 2
EXIT
MIN SEC
00 : 00
– +
EXIT
ALL
OFF