SanDisk CLIP VOICE User Manual page 37

Please note that changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures: -
-Reorient or relocate the receiving antenna. –Increase the separation between the
equipment and receiver. –Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. –Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
For more information regarding the FCC compliance, go to:
http://kb.sandisk.com/app/answers/detail/a_id/19838
Western Digital Technologies, Inc. is the seller of record and licensee in the
®
Americas of SanDisk products.
SanDisk is a trademark of Western Digital Corporation or its affiliates, registered in the U.S.
and other countries. The Bluetooth® word mark and logos are registered trademarks owned
by Bluetooth SIG, Inc. and any use of such marks by Western Digital Technologies, Inc. is
under license. All other trademarks are the property of their respective owners.
©2016 Western Digital Corporation or its affiliates. All rights reserved. Made in China.
Service & Warranty
37