Heater Assembly; Pump; Thermistor - LG WD(M)-14400(5)TB Service Manual

DRAIN PUMP ASSEMLBY

HEATER ASSEMBLY

THERMISTOR

Remove pump outlet hose.
Remove tub pump bellows.
Remove cap (Remaining Hose.)
Disconnect the wiring.
Unscrew 2 screws.
Remove the pump.
Loosen the M6 heater nuts to pull out the HEATER
ASSEMBLY.
CAUTION
When mounting the HEATER ASSEMBLY be sure to
insert the HEATER ASSEMBLY into the heater clip on
the bottom of the tub.
Pull it out by holding the THERMISTOR bracket.
If it is pulled by the wire, it may be broken.
When mounting the THERMISTOR again, make sure
that it is got back tight to the bushing.
30