Advertisement
12 electrolux what to do if...
the surface. Wipe the appliance with a
damp cloth and a little washing up liquid.
Finally, rub the appliance dry using a
clean cloth .
2. Limescale rings, water rings, fat
splashes, shiny metallic discolorations
What to do if ...
Problem
The appliance cannot be switch-
ed on or is not operating
The residual heat indicator is not
displaying anything
The automatic warm up function
is not switching itself on
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds when
appliance is switched off
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
Display is switching between
two heat settings
lights up
should be removed after the appliance
has cooled down using cleaner for glass
ceramic or stainless steel.
Warning! Do not use a steam cleaner to
clean this appliance.
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The lock is switched on
The child safety device is switch-
ed on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
The cooking zone was only on
for a short time and is therefore
not hot
There is still residual heat on the
cooking zone
The highest heat setting is set
One or more sensor fields have
been covered for longer than 10
seconds
The control panel is wholly or
partly covered by objects.
The On/Off sensor field has
been covered up, e.g. by a cloth
Power management is reducing
the power of this cooking zone
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom of
the cookware is too small for the
cooking zone
Remedy
Switch the appliance on again.
Switch off the lock (See the sec-
tion "Locking/unlocking the con-
trol panel")
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on the
control panel. Switch the appli-
ance on again
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
Let the cooking zone cool down
The highest heat setting has the
same power as the automatic
warm up function
Uncover sensor field
Remove objects.
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking
zone
Hide quick links:
Advertisement
