Mitsubishi 290p106010 Operating Manual page 4

Part IV: Operation
Programming the Remote Control to Control NetCommand ™ A/V
Products
To Program the Remote to Control
NetCommand A/V Products:
(See NetCommand Supported Devices, page 16, for
the list of A/V products supported by the NetCom-
mand System.)
1
M ove the slide switch at the top of the
remote to the T V laye r.
2
P ress and hold the P O W ER button on
the rem ote control.
3
Ente r the three digit code of 935, and
then release the P O W ER button on the
remote control.
T he rem ote control is now programme d
to send N etC ommand™ signals to the
T V so the T V can control the IEEE
1394 devices and sele cte d olde r N et-
C ommand™ supporte d IR devices. S ee
the N etC ommand™ guide for details.
Figure 1. Programming the remote to control your Net-
Command™ A/V devices.