Satellite Link
You can set the unit to start recording whenever it detects
the video signal from the external tuner.
Preparing for the satellite link timer recording:
Preparation on the tuner
• The satellite link accepts only the connection from L1 (rear)
with the external tuner. (The connection from L2 cannot
read any signals from the external tuner.)
• The external tuner should be equipped with some kind
of timer function. Using the timer function of the tuner,
set it to output audio/video signals when it is time to start
recording, and stop output audio/video signals when it is
time to finish recording. Refer to the tuner's manual on
how to set the timer.
• Make sure to set the satellite link standby mode when you
finish programming.
1
Press [SETUP].
2
Use [K / L] to select "Timer Programming", then press
[OK].
3
Use [K / L] to select "Satellite Link", then press [OK].
Timer Programming
Timer Programming
Satellite Link
4
Use [K / L] to select the time, media and recording
mode, then press [OK].
Satellite Link
DVD
Start
Mode
VCR
5:00PM
DVD
SP
To Standby Mode
5
Use [K / L] to set a desired starting time, then press
[ 1].
• The hour can be selected from 1 to 12 with AM or PM.
• Repeat the procedures in step 5 to set a desired minutes.
• If you would like to go back to the left, press [0 ].
6
Use [K / L] to select the recording media ("DVD" or
"VCR"), then press [ 1].
7
Use [K / L] to select the recording mode.
• Refer to "Recording Mode" (p.24) for details.
8
Press [OK].
• "To Standby Mode" will be highlighted.
EN
9
Press [OK] again.
Satellite Link
DVD
Start
Mode
VCR
5:00PM
DVD
To Standby Mode
• The unit will then turn Off automatically as it goes into
satellite link standby mode.
To cancel the satellite link function while in satellite link
standby mode:
Press [TIMER SET] to turn On the unit.
To cancel the satellite link function while the satellite
link recording is in progress:
Press [ C] on the front panel to stop the disc recording.
Press [ C A] on the front panel to stop the cassette tape
recording.
Note(s)
• If the signal of the external input breaks up over 5 seconds, the
satellite link function will be cancelled.
• If you have not set the clock, the "Clock Setting" menu will
appear in step 4. Follow step 4 in "Clock Setting" (p.24).
• You cannot set the ending time for the satellite link timer
recording on this unit.
• Recording picture will be distorted if the copy protection signal
is being detected during satellite link timer recording.
• You can record the satellite link by using S-video input jacks on
the rear panel. Refer to "Connecting to a TV with an S-Video
Input Jack" (p.17) for more information.
• When a regular timer recording and the satellite link timer
recording are overlapped, those recordings are recorded as
illustrated below.
• Press [TIMER] during the satellite link timer recording to check
the satellite link timer recording in progress.
example 1
timer
recording
satellite link
actual
recording
The first 2 minutes (at most) will be cut off.
example 2
timer
recording
satellite link
actual
recording
example 3
timer
recording
satellite link
actual
recording
The first 2 minutes (at most) will be cut off.
– 31 –
SP
Continued on next page.