Navigationssystem_111.5U6.N31_23.book Seite 45 Donnerstag, 22. April 2010 5:16 17
Destination memory
Introduction
In this section you'll find information on the fol-
lowing:
position . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The destination memory is used for the manual
saving of destinations.
Automatically saved recent destinations
Fig. 53 List of recent destinations.
Navigation
Function buttons to save a trip destination are only
active and accessible if the the destination has
been sufficiently defined.
45
Stored destinations can be used for route guidance
46
and can be edited.
46
Supplementary information:
47
•
Safety instructions
48
•
Device overview ⇒ page 6
•
Introduction to navigation ⇒ page 37
•
Destination input ⇒ page 41
Please first read and observe the safety in-
structions
on page 3 and the introduc-
tory information on page 45.
Destinations which were entered for route guid-
ance are automatically saved in the Last Destina-
tions list ⇒
fig.
53.
Older recent destinations are automatically over-
written by newer destinations if the list is full. In
order to permanently save a recent destination the
destination must be stored in the Destination
memory.
•
Open the Last Destinations list via the Naviga-
tion main menu ⇒ page 37.
•
Tag a listed destination which is to be added to
the recent destinations list ⇒
•
Press the
function button to save the des-
Save
tination ⇒ page 46.
⇒ page 3
fig.
53.
44
45