Pnp Input/Output For Fz5 Series - Omron fh series Hardware Manual

6-1-5

PNP Input/Output for FZ5 Series

Parallel interface differs the appropriated Sensor Controller depending on NPN output and PNP output.
Encoder interface (open corrector type) is also included.
Encoder interface (open corrector type) is ENCTRIG_A0, ENCTRIG_B0, and ENCTRIG_Z0
Wire the pins to Encoder appropriately.
PNP I/O type
• Camera 2ch type: FZ5-1105/FZ5-605
• Camera 4ch type: FZ5-1105-10/FZ5-605-10
Interface Specification
• Specifications differ by number of pins.
• Encoder interface (open corrector type) is ENCTRIG_A0 (B2pin), ENCTRIG_B0 (B3pin), and
ENCTRIG_Z0 (B4 pin). The frequency response of Encoder interface (open corrector type) is 0.95
KHz.
[Input]
Applicable signals:
RESET, DI0 to DI7, DSA0, DSA1
Item
Input voltage
*1
ON current
*1
ON voltage
*2
OFF current
*2
OFF voltage
ON delay
OFF delay
*1. ON current and ON voltage:
Those mean the current or voltage to turn ON from OFF. The ON voltage value is the potential difference
between COMIN and each input terminal.
*2. OFF current and OFF voltage:
Those mean the current or voltage to turn OFF from ON. The OFF voltage value is the potential difference
between COMIN and each input terminal.
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
12 to 24 VDC ±10%
5 mA min.
8.8 V min.
0.5 mA max.
1.1 V max.
5 ms max.
0.7 ms max.
6 I/O Interface
Specifications
6
6 - 23