How To Use - Audiovox VOD10PS2 Operation Manual

WIRELESS CONTROLLER (2.4GHz)
Carefully read the information before use. For detailed connection and
usage methods, refer to the Owner's Manual for the PIayStation2 system.

HOW TO USE

Battery Installation:
The wireless controller uses two "AA" batteries.
1. Turn your controller upside down and remove the lid on the bottom by pressing against
the lip and pulling the lid away.
2. Insert the batteries as indicated in the controller.
3. Once the batteries are inserted, put the lid back in its place and cover the batteries.
Safety Precaution: Follow the battery manufacturer's instructions as well as
there important safety tips. Do not open or mutilate batteries as they might leak
dangerous chemicals.
T
he wireless transceivers are pre-installed in the controller ports on your PlayStation2 system.
Turning On the Controller:
1. Turn on your PlayStation2 system. Press the green reset button on the remote control if
the PlayStation2 does not come on when the main unit is turned on.
2 Place the ON/OFF switch for your controller, which is located between the dual analog
joy sticks, to ON. The POWER LED will illuminate green.
3. Once the controller has been powered on, the PlayStation2 will recognize the wireless
controller. The MODE LED indicator will illuminate red on the wireless controller, indicating
the connection between the wireless controller and the receiver. The green Rx LED on the
PlayStation2 transceiver will illuminate a steady green.
15
ON/OFF Switch
MODE LED
POWER LED