Advertisement
Q1/2
X 4-1/2"
REVERSE VIEW
FOR ASSEMBLY
FIGURE 9
;TEP 9:
¯ SECURELY
reassemble the LEFT (8) and RIGHT (9) RAILS to the REAR UPRIGHT (6) as shown in FIGURE 9 using the two
X 4-1/2" BOLTS (43), four 1/2" WASHERS (32), and two 1/2" LOCK NUTS (33). (!!!
IMPORTANT
!!! BEFORE TIGttTENING
MOVE THE RAILS IN AS FAR AS POSSIBLE)
¯ SECURELY tightenthe
two 3/8 X 4-1/2" BOLTS (38) holding the SEAT PAD (18) from STEP 5. (!!!
IMPORTANT
!!! BEFORE
TIGHTENING MOVE THE RAILS IN AS FAR AS POSSIBLE)
¯ To adjust the side to side movement of the CARRIAGE
(16), start by sliding the CARRIAGE
(16) as far to the lefI as possible
inside the RAILS (8 & 9). Adjust the ADJ. WHEEL BRACKETS
(14) out until the 2" DIA. WHEELS (21) contact the
RAIL (9). SECURELY tighten bolt connection.
See FIGURE 9 and REVERSE CARRIAGE VIEW.
11
Advertisement
