Touch Sensor Module Removal - Sony KDL-40XBR7 Service Manual

1-10. TOUCH SENSOR MODULE REMOVAL

1
Disconnect 1 connector and remove Illumination Module from Center Cabinet
2
Release Touch Holder from Center Cabinet
3
Disconnect 1 connector and remove Touch Sensor Module from Center Cabinet
4
Carefully remove Touch Sheet from Center Cabinet
Caution: Touch Sensor Removal
The board has been installed and fi xed in position on the bezel by double sided tape. Improper removal may cause damage on both
the board and the light guide. Do not bend or warp the board as shown on the pictures on the below.
To remove the module,
* Hold 2 positions (or more) to minimize board distortion.
* Use jigs (wide plates) to avoid damaging light guide while separating the module from Bezel.
KDL-40XBR7
Illumination Module
1
"NG"
2
Touch Holder
3
Touch Sensor Module
4
Touch Sheet
"OK"
KDL-40XBR7
18